Grizzly BL8551 Manuale Utente
H8069 Heirloom Stratocaster-Style Guitar Kit
-23-
4. Tune the 4th string by playing the 5th string
while it is being pressed (fretted) at the 5th
fret, and then play the open 4th string. Adjust
the 4th string tuner until the notes match.
fret, and then play the open 4th string. Adjust
the 4th string tuner until the notes match.
5. Perform the same tuning step on the 3rd and
4th string.
6. When tuning the 2nd string, fret the 3rd string
at the 4th fret instead of the 5th fret.
7. Tune the 1st string in the same manner as
the 6th, 5th, 4th, and 3rd strings.
Setting Intonation
Tools Needed
Qty
Phillips Head Screwdriver ...................................1
Setting the intonation adjusts the length of the
string to correct for flatness/sharpness on each
string. This is a simple process that takes a lot of
trial-and-error.
string to correct for flatness/sharpness on each
string. This is a simple process that takes a lot of
trial-and-error.
To set the intonation:
1. Lightly touch and then release the 1st string
directly above the twelfth fret as you pluck the
string to play a harmonic note.
string to play a harmonic note.
2. Now pluck the string while holding it fretted at
the twelfth fret. If this note is sharper than the
note played in
note played in
Step 1, move the saddle away
from the neck by turning the saddle adjust-
ment screw (
ment screw (
Figure 41) clockwise. If this note
is flat in comparison, move the saddle toward
the neck.
the neck.
Figure 41. Example of saddle adjustment screw.
Note: This can also be done with an elec-
tronic tuner by tuning the harmonic note to
be exactly in tune and then adjusting the
saddle until the note played in
tronic tuner by tuning the harmonic note to
be exactly in tune and then adjusting the
saddle until the note played in
Step 2 is also
in tune.
3. Repeat Steps 1–2 until the string is in
tune. Repeat the process for the rest of the
strings.
strings.
Adjustment
Screw
Tremolo Adjustment
Tools Needed
Phillips Head Screwdriver ...................................1
Phillips Head Screwdriver ...................................1
To adjust the tremolo springs:
1. Remove the tremolo cavity cover.
2. Install the four tremolo springs as shown in
Figure 42.
3. Remove the wedge.
—If the wedge is dififcult to remove, tighten
the spring hanger screws until the wedge
loosens.
loosens.
Note: The spring hanger should be approxi-
mately
mately
5
⁄
8
" from the front edge of the tremolo
cavity.
4. Replace the tremolo cavity cover.
Figure 42. Correct spring placement.
5
⁄
8
"