Roland TD-6V Manuale Utente

 

 is a function in which a pad is selected either by 

striking the pad or when MIDI data corresponding to that pad 
is received. 
When set to “OFF,” the pad’s settings screen is prevented 
from switching, even when MIDI data for a pad is received. 
Here, the trigger input number appears in brackets ([ ]).
If you want to set other pads with this setting remaining at 
“OFF,” you can switch settings screens by holding down [SHIFT] 

and pressing [

] or [

] to select the trigger input number.

 

fig.07-008_50

 

You can use only the TOM2 rim or AUX, and only the TOM3 
rim or TOM4. You cannot select the trigger input for any pad 
for which the trigger type has not been set.
Also refer to “Connecting Two Pads to Trigger Input 5/6 
(TOM2/AUX) and 7/8 (TOM3/4)” (p. 70).

 

This setting is required when you wish to record your pads and 
internal sequencer performance on an external MIDI sequencer.
The performance data from the pads and internal sequencer, 
rather than being sent directly to the sound module section (Local 
Control Off), is first sent to the external sequencer, and then on to 
the TD-6V’s sound module.

 

fig.07-009.e

 

• The settings screen does not appear in GM mode.

• If you make connections and record as shown, with a 

setting of Local On, duplicate notes will be re-transmitted 
to the TD-6V and will not be played correctly.

 

fig.07-010_50

 

The pads and internal sequencer are disconnected from the 
TD-6V’s internal sound generator. Striking the pads does not 
cause sound to be produced by the internal sound generator.

 

The pads and internal sequencer are connected to the TD-6V’s 
internal sound generator. Sounds are produced by the internal 
sound generator when the pads are struck.

Internal Sound Generator

OUT/THRU

Trigger Input

OUT

IN

IN

Internal

Sequencer

Trigger    MIDI

Converter

LocalControl:

OFF

TD-6KV_e.book 97 ページ ２００５年１月２４日　月曜日　午後７時４分