Roland GW-8 Manuale Utente
14
Introduction
Non-Rewritable memory
Preset memory
Data in Preset memory cannot be rewritten. However, you can
call up settings from preset Performances into the temporary
area, modify them and then store the modified data in
rewritable memory.
call up settings from preset Performances into the temporary
area, modify them and then store the modified data in
rewritable memory.
USB memory
You can back up your settings to USB memory in the following
units of data. (p. 49)
units of data. (p. 49)
• Sound/System
User Performances, Favorite Tones/Performances, system
settings
settings
• Style
User Styles
• Song
User Songs
• All
Style and Song in addition to the Sound/System data
listed above
listed above
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
When connection cables with resistors are used, the volume
level of equipment connected to the input (EXT INPUT jack)
may be low. If this happens, use connection cables that do not
contain resistors.
level of equipment connected to the input (EXT INPUT jack)
may be low. If this happens, use connection cables that do not
contain resistors.
1.
Make sure that the [POWER] switch is off.
2.
Move the VOLUME knob all the way to the left to minimize
the volume.
3.
Connect the included power cord to the included AC
adaptor.
The indicator will light when you plug the AC adaptor into
an AC outlet.
an AC outlet.
fig.ACadap.eps
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.
illustration) faces upwards and the side with textual
information faces downwards.
Depending on your region, the included AC adaptor may be
a different type than the one shown above. If so, omit step 3
and proceed.
a different type than the one shown above. If so, omit step 3
and proceed.
4.
Connect the AC adaptor to the DC IN jack on the GW-8’s
rear panel, and then plug the AC adaptor into an electrical
outlet.
To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Even if the cord is fastened, strong tension applied to the cord
may cause it to be damaged or broken. Be careful not to pull
the cord accidentally, or to apply strong pressure to it.
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Even if the cord is fastened, strong tension applied to the cord
may cause it to be damaged or broken. Be careful not to pull
the cord accidentally, or to apply strong pressure to it.
Making Connections
Connecting the AC Adaptor
to an AC outlet
AC adaptor
Power cord
Indicator
GW-8_e.book 14 ページ ２００８年４月１日 火曜日 午前１１時４４分