Roland KF-90 Manuale Utente
140
Chapter 7 Using Other Functions
Saving User Programs on
Floppy Disk
You can save all User Programs now stored on the [User
Program] button (internal memory) on floppy disk as a
single set.
1.
Insert the floppy disk into the disk drive.
2.
Press the [User Program] button.
3.
Touch <Disk>.
fig.07-17.e
4.
Touch <Save>.
The following screen will appear.
fig.07-18.e
5.
Touch
and
to scroll the cursor sideways,
and enter the name of the button by using the
Value [-] [+] buttons or the dial to choose the
letters.
Touch <A-a-0-!> at the bottom of the screen to change
the type of script.
Each touch of <A-a-0-!> cycles the type of characters
through “English (upper case),” “English (lower case),”
“numerals,” “symbols,” then back to “English (upper
case).”
To delete the character under the cursor, touch <_>.
6.
After you’ve entered a name, touch
to
choose a destination for saving the User Program.
* If you save a User Program at a place where another User
Program has already been saved, the previously saved User
Program is erased and the new one is saved.
Program is erased and the new one is saved.
Touch <Exit> to go back to the previous screen.
7.
Touch <Save> to start saving.
→ You can erase a User Program saved on a floppy disk. Take a
* Don’t take the floppy disk out of the disk drive until the saving
process is finished.
■
Calling Up Saved User
Programs from Floppy Disk
Programs from Floppy Disk
You can call up an entire set of User Programs saved on
floppy disk to the [User Program] button.
* Please note that calling up User Programs from floppy disk
erases all User Programs stored at the [User Program] button.
1.
Insert the floppy disk into the disk drive.
2.
Press the [User Program] button.
3.
Touch <Disk>.
4.
Touch <Load>.
The following screen will appear.
fig.07-19.e
5.
Touch the screen to select the User Program set
you want to call up.
6.
Touch <Load> at the bottom of the screen.
The User Program saved on a floppy disk will be loaded
to the [User Program] button (internal memory).