Roland VR-700 Manuale Utente
51
Various Settings (Function mode)
1.
Press the [FUNCTION/ENTER] button.
The VR-700 will enter Function mode, and the display will indicate
.
2.
Use the [+] button or [–] button to select the group
containing the parameter you want to edit.
The sound buttons will blink.
3.
After you’ve selected the group, press the sound button
that corresponds to the parameter that you want to edit.
For the correspondence between parameters and sound buttons,
refer to the pages listed above.
4.
Use the [+] button or [–] button to edit the value of the
parameter.
5.
When you’ve finished editing, press the [DISPLAY/EXIT]
button to return to the state of selecting a group.
6.
Press the [DISPLAY/EXIT] button once again to exit
Function mode.
You can edit the value of a parameter by using the [–] button or [+]
button.
Depending on how you press these buttons, the value will change
as follows.
* The factory settings of the system parameters are listed in the table
on the next and following pages.
* In the case of parameters stored as a Favorite, pressing the [–]
button and [+] button simultaneously will reset the parameter to a
certain value, but please be aware that this is not the value stored in
the Favorite settings.
Of the parameters that can be set in Function mode, some
parameters are stored as part of the system. The setting changes
you make for such system parameters can be stored by carrying out
the following procedure.
1.
Edit the value of the parameter.
2.
Press the [WRITE] button.
The display will indicate
.
3.
To write the edited value into memory, press the
[FUNCTION/ENTER] button.
If you decide not to write the edited value, press [DISPLAY/EXIT].
Operations in Function Mode
Display
Group
Refer to...
Organ sound parameters
Percussion parameters
Rotary parameters
Ensemble sound parameters
Equalizer settings
Pedal, bend lever, and foot
controller settings
controller settings
Player parameters
MIDI input/output settings
System settings
V-LINK settings
Deleting favorite sets,
formatting USB memory,
initializing the system
formatting USB memory,
initializing the system
Editing Parameter Values
Operation
Change in value
Press the [+] button
Value increases
Press the [–] button
Value decreases
Hold down the [+] button
Value continues increasing
Hold down the [–] button
Value continues decreasing
Hold down the [+] button and
press the [–] button
press the [–] button
Value increases rapidly
Hold down the [–] button and
press the [+] button
press the [+] button
Value decreases rapidly
Press the [+] button and [–]
button simultaneously
button simultaneously
Value is reset to the factory-set value
Confirming System Parameters
VR-700_e.book 51 ページ ２００９年１１月１８日 水曜日 午前９時２４分