Roland XV-88 Manuale Utente
178
Chapter 9. Getting More Familiar with the XV-88 (System Functions)
Checking the Installation of the
Wave Expansion Board and
Controlling External MIDI Devices
(INFO)
Wave Expansion Board and
Controlling External MIDI Devices
(INFO)
INFO EXP
(Information Expansion Board)
(Information Expansion Board)
fig.09-24
The display shows the names of Wave Expansion Boards
installed in slots EXP A–D.
installed in slots EXP A–D.
Slots without any boards installed are shown as “----------------.”
BATTERY CHECK
fig.09-25
The XV-88 contains a battery that retains the data in its
internal memory when the unit’s power is turned off. This
display allows you to check the battery voltage. If the display
says “OK,” there is sufficient voltage. If the display says
“LOW,” the battery’s voltage is getting low. Contact the
nearest Roland Service Center as soon as possible, and have
the battery replaced.
internal memory when the unit’s power is turned off. This
display allows you to check the battery voltage. If the display
says “OK,” there is sufficient voltage. If the display says
“LOW,” the battery’s voltage is getting low. Contact the
nearest Roland Service Center as soon as possible, and have
the battery replaced.
TRANSMIT P.C
(Transmit Program Change)
(Transmit Program Change)
fig.09-26
When you want to transmit MIDI messages (Program Change
and Bank Select) to select sounds on an external MIDI device,
make settings in this display and then press [ENTER].
and Bank Select) to select sounds on an external MIDI device,
make settings in this display and then press [ENTER].
Ch (Transmit MIDI Channel)
Selects the channel on which the MIDI message will be
transmitted.
transmitted.
P.C# (Transmit Program Change Number)
Selects the Program Change number you wish to transmit.
Bank Select MSB/LSB
(Transmit Bank Select MSB/LSB)
(Transmit Bank Select MSB/LSB)
Selects the Bank Select number MSB (Controller number 0)
and LSB (Controller number 32) you want to transmit.
and LSB (Controller number 32) you want to transmit.
Information on the XV-88 Tone Group/Bank
corresponding to the Bank Select message sent is
displayed in parentheses.
corresponding to the Bank Select message sent is
displayed in parentheses.
TRANSMIT SONG SEL
(Transmit Song Select)
(Transmit Song Select)
fig.09-27
This transmits a MIDI message (Song Select) to the external
MIDI device in order to change the song.
MIDI device in order to change the song.
Song Number (Transmit Song Select Number)
Selects the Song Select number you wish to transmit.
Holding down [SHIFT] while pressing
(or
) in
a PLAY page selects the song before (or after) the Song
Number set with the Song Number parameter.
Number set with the Song Number parameter.