Roland XV-88 Manuale Utente
215
Troubleshooting
Appendices
Is the rear panel COMPUTER switch set to the
correct position?
correct position?
• If you are using the XV-88 while connected to a
computer, make settings as appropriate for the
connection method, the type of computer, and the
settings of the driver (p. 208).
connection method, the type of computer, and the
settings of the driver (p. 208).
* Before changing the setting of the Computer switch, you must
first turn off the power on the XV-88.
Song Data Does Not Play Back
Correctly
Correctly
When playing back a GM score, is the sound
generator set to GM mode?
generator set to GM mode?
Has the Receive General MIDI/General MIDI 2
System On Switch been turned ON?
System On Switch been turned ON?
• Set the Rx GM On/Rx GM2 On parameter (SYSTEM/
Are you playing back from the middle of the
song?
song?
• The beginning of a GM score song contains a General
MIDI/General MIDI 2 System On message. In some
cases, a GM Score cannot be played back correctly unless
this message is received.
cases, a GM Score cannot be played back correctly unless
this message is received.
Are you playing back GS format song data?
When the XV-88 receives a GS Reset message, the XV-88 is
enabled for the GS format. This permits playback of music
data bearing the GS logo (GS music data). However, data
created exclusively for the Sound Canvas Series may not play
back properly on the XV-88.
enabled for the GS format. This permits playback of music
data bearing the GS logo (GS music data). However, data
created exclusively for the Sound Canvas Series may not play
back properly on the XV-88.
A Specific Part Does Not Sound
Has the volume level of the part been
lowered?
lowered?
Adjust the Level parameter (PERFORM/PART/SETTING) to
raise the volume of the part that is not heard (p. 53).
raise the volume of the part that is not heard (p. 53).
Is the instrument set to receive MIDI
messages?
messages?
• Set the Rx Sw parameter (PERFORM/MIDI/MIDI) to
Does the MIDI Receive channel of the Part
match the MIDI Transmit channel of the
connected MIDI device?
match the MIDI Transmit channel of the
connected MIDI device?
• Set the Channel parameter (PERFORM/MIDI/MIDI) to
No Sound from Connected MIDI
Device
Device
Is the instrument set to transmit MIDI
messages?
messages?
• In the Patch/Rhythm Set mode, set the Tx Ch parameter
• In the Performance mode, set the Tx parameter (ZONE/
Does the MIDI transmit channel for the XV-
88’s keyboard controller section match the
MIDI receive channel for the connected MIDI
device?
88’s keyboard controller section match the
MIDI receive channel for the connected MIDI
device?
• In the Patch/Rhythm Set mode, set the Tx Ch parameter
• In the Performance mode, set the MIDI transmit channel
A Specific Keyboard Area Does
Not Sound
Not Sound
Has a restricted range of notes been set?
• If a specific range of notes does not sound, check the Key
Range settings for the Patch Tone, the Performance Part,
and the Zone in the following KEY RANG pages.
and the Zone in the following KEY RANG pages.
Tone Key Range
Part Key Range
Zone Key Range