Roland XV-88 Manuale Utente

225

Quick Reference of Procedures

Appendices

Saving and Loading Data

Controlling Multi-effects
Parameters by the Slider
or Pedal
(Multi-effects Controller)

Up to four Multi-effects Controllers can be used in a single
Performance/Patch/Rhythm Set.

1. Specify the MIDI messages to be controlled by each

controller (the C1–C4 slider, control pedal etc.) (see
previous).

2. The multi-effects Source parameter (PERFORM/

EFFECTS/MFX TYPE) is set to PERFORM, set the Control
channel (the receive channel of control destination) (only
Performance).

MFX Control Channel parameter (PERFORM/
COMMON/PERFORM MFX CH)

3. Choose a control source (MIDI messages used for control).

Source parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)

* If you do not need to set different control sources for each

Performance/Patch/Rhythm Set, select SYS-CTRL 1–4, and use
the Control 1–4 parameters (SYSTEM/CONTROL/SYS CTRL
ASSIGN 1–4) to choose the MIDI messages that you wish to
use for control.

4. Specify the control destination (the parameter to be

controlled).

Destination parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)

5. Set the Control Sensitivity (the amount of the effect that is

applied).

Sens parameter (PERFORM, PATCH, RHYTHM/
EFFECTS/MFX CTRL 1–4)

Adjusting the Keyboard
Response

Sens parameter (SYSTEM/CONTROL/KEYBOARD)

Set the Keyboard to
Produce a Fixed Velocity

Vel parameter (SYSTEM/CONTROL/KEYBOARD)

Saving Performance
Settings

1. In Performance mode, press [UTILITY].

2. Select “1. WRITE” on the UTIL 1 page.

3. Specify the writing destination.

4. Press [ENTER].

If a message of “Internal Write Protect= ON” appears,
change it to OFF and press [ENTER] twice.