Roland XV-88 Manuale Utente
63
Chapter 4. Zone Settings
Chapter 4
Key Velocity
Specifies the loudness of the notes that you play.
If you want the velocity value to change according to how
strongly you played each note, set this to REAL. If you want
each note to have a fixed velocity regardless of how strongly
you play the keyboard, set this parameter to the desired
value (1–127).
strongly you played each note, set this to REAL. If you want
each note to have a fixed velocity regardless of how strongly
you play the keyboard, set this parameter to the desired
value (1–127).
Zone (Arpeggio Zone)
Arpeggio Zone sets the Zone for playing an Arpeggio
performance when a Layer Performance is being selected.
The Arpeggio performance corresponding to the Part
connected to the Zone set here is played.
performance when a Layer Performance is being selected.
The Arpeggio performance corresponding to the Part
connected to the Zone set here is played.
When a Single Performance is selected, this setting is
disabled, and the single specified Part (current Part) will
play arpeggios.
disabled, and the single specified Part (current Part) will
play arpeggios.
Tempo (Arpeggio Tempo)
Sets the speed of the arpeggio.
When the Clock Source parameter (SYSTEM/SETUP/
SYSTEM SETUP) is set to INT, the display will indicate
Tempo(=SYS), and this will be the same value as the system
tempo. With a setting of MIDI, the display will indicate
Tempo(=EXT), and you will be synchronized to the clock of
the external MIDI device.
SYSTEM SETUP) is set to INT, the display will indicate
Tempo(=SYS), and this will be the same value as the system
tempo. With a setting of MIDI, the display will indicate
Tempo(=EXT), and you will be synchronized to the clock of
the external MIDI device.
Setting the D Beam Controller
(D BEAM)
(D BEAM)
This is where the settings are made for applying effects to the
sound by moving your hand over the D Beam controller in
Performance mode.
sound by moving your hand over the D Beam controller in
Performance mode.
When using the D Beam controller in Patch/Rhythm
Set/GM mode, the settings are made in System mode (p.
176).
Set/GM mode, the settings are made in System mode (p.
176).
D BEAM CONTROL
fig.04-16
Assign (D Beam Assign)
Specifies the function controlled by the D Beam controller.
CC01–31, 33–95
: Controller numbers 1–31, 33–95
For more information about Control Change messages,
please refer to
please refer to
PITCH BEND
: Pitch Bend
AFTERTOUCH
: Aftertouch
OCT UP
: Raises the key range in octave steps (up to 3 octaves
higher).
OCT DOWN
: Lowers the key range in octave steps (up to 3
octaves lower).
START/STOP
: Starts/Stops the external sequencer.
TAP TEMPO
: Tap tempo (a tempo specified by the interval
at which you move your hand over the D Beam controller).
Output (D Beam Output)
Selects the sound generator(s) (the internal sound generator
and/or external sound generators connected to MIDI OUT
connector) to be controlled by the D Beam controller.
and/or external sound generators connected to MIDI OUT
connector) to be controlled by the D Beam controller.
OFF
: Neither will be controlled.
INT
: Only the internal sound generator will be controlled.
MIDI
: Only external sound generators will be controlled.
BOTH
: Both the internal sound generator and external sound
generators will be controlled.
Polarity (D Beam Polarity)
Switches the polarity of the D Beam controller.
With a setting of REVERSE, the direction of control for the D
Beam controller will be inverted.
Beam controller will be inverted.