Roland AX-Synth Manuale Utente

Editing Tone settings

Though most sound parameter can only be edited using 
the dedicated “AX-Synth Editor” software and a com-
puter, you can change the volume and Reverb Send lev-
els of the Tones on the AX-Synth itself and save those 
changes to a FAVORITE memory.

Note: The two parameters discussed here are not available for 
SuperNATURAL or SPECIAL Tones.

Note: All parameters of the AX-Synth can be edited using the 
dedicated “AX-Synth Editor” software. This software can be 
downloaded free of charge from Roland’s website (http://
www.Roland.com).

(1) Select the “regular” Tone whose volume and or 

Note: The “VOl” and “reU” parameters are not available 
for SuperNATURAL or SPECIAL Tones.

(2) Press and keep holding the 

[SHIFT] button.

The display now shows “---”.

(3) Keep holding the 

[SHIFT] button and press the TONE 

button of the sound you selected in step (1) above 
(i.e. the button that lights).
The “UOL” message briefly flashes in the display.

This message refers to the Tone’s volume parameter.

Note: Skip to step (6) if you only need to change the 
Reverb Send level.

(4) Wait until the volume value is displayed.

(5) Keep holding the 

[SHIFT] button and use VARIATION 

[DEC÷–]/[INC÷+] to select the desired setting (0~127).

Note: You can hold down VARIATION [DEC÷–] or [INC÷+], or 
hold one while pressing the other to speed up this opera-
tion.

Note: If you don’t need to change the Reverb Send level, 
skip to step (9).

(6) Press the TONE button used in step (3) again.

The “reU” message briefly flashes in the display:

This message refers to the Tone’s Reverb Send param-
eter.

(7) Wait until the Reverb Send value is displayed.

(8) Keep holding the 

[SHIFT] button and use VARIATION 

[DEC÷–]/[INC÷+] to select the desired setting (0~127).

Note: You can hold down VARIATION [DEC÷–] or [INC÷+], or 
hold one while pressing the other to speed up this opera-
tion.

(9) Release the 

[SHIFT] button.

(10) Start playing to check whether your settings corre-

spond to what you had in mind.

Note: Do not select other sounds at this stage, or switch 
off the AX-Synth, because that would cancel the settings 
you have made so far.

(11) Press the 

[WRITE] button.

The 

[WRITE] button now flashes.

(12) Press the FAVORITE 

[A] or [B] button to select the 

bank and then choose

(13) Press one of the eight TONE buttons to select the 

target memory.

UOl

reU

AX-Synth_e2  Page 26  Monday, October 12, 2009  3:41 PM