Roland AX-Synth Manuale Utente

 

Important notes

 

 

• The AX-Synth can be operated using 8 rechargeable AA-type 

Ni-MH batteries or the supplied adaptor. Be careful to insert the 
batteries the right way around. If you prefer to use the adaptor, be 
sure to use the enclosed Roland PSB-1U model.

• Do not connect this unit to same electrical outlet that is being 

used by an electrical appliance that is controlled by an inverter 
(such as a refrigerator, washing machine, microwave oven, or air 
conditioner), or that contains a motor. Depending on the way in 
which the electrical appliance is used, power supply noise may 
cause this unit to malfunction or may produce audible noise. If it is 
not practical to use a separate electrical outlet, connect a power 
supply noise filter between this unit and the electrical outlet.

• The AC adaptor will begin to generate heat after long hours of 

consecutive use. This is normal, and is not a cause for concern. 

• The use of an AC adaptor is recommended as the unit’s power 

consumption is relatively high. Should you prefer to use batteries, 
please use the rechargeable AA-type Ni-MH type. 

• When installing or replacing batteries, always turn off the power 

on this unit and disconnect any other devices you may have con-
nected. This way, you can prevent malfunction and/or damage to 
speakers or other devices. 

• Before connecting the AX-Synth to other devices, turn off the 

power to all units. This will help prevent malfunctions and/or dam-
age to other devices.

 

• Using the unit near power amplifiers (or other equipment contain-

ing large power transformers) may induce hum. To alleviate the 
problem, change the orientation of this unit; or move it farther 
away from the source of interference.

• This device may interfere with radio and television reception. Do 

not use this device in the vicinity of such receivers.

• Noise may be produced if wireless communications devices, such 

as cell phones, are operated in the vicinity of this unit. Such noise 
could occur when receiving or initiating a call, or while conversing. 
Should you experience such problems, you should relocate such 
wireless devices so they are at a greater distance from this unit, or 
switch them off.

• Do not expose the AX-Synth to direct sunlight, place it near 

devices that radiate heat, leave it inside an enclosed vehicle, or 
otherwise subject it to temperature extremes. Excessive heat can 
deform or discolor the instrument.

• When moved from one location to another where the temperature 

and/or humidity is very different, water droplets (condensation) 
may form inside the AX-Synth. Damage or malfunction may result 
if you attempt to use the AX-Synth in this condition. Therefore, 
before using the AX-Synth, you must allow it to stand for several 
hours, until the condensation has completely evaporated. 

• Do not allow objects to remain on top of the keyboard. This can be 

the cause of malfunction, such as keys ceasing to produce sound.

• Depending on the material and temperature of the surface on 

which you place the unit, its rubber feet may discolor or mar the 
surface. 
You can place a piece of felt or cloth under the rubber feet to pre-
vent this from happening. If you do so, please make sure that the 
unit will not slip or move accidentally.

 

• For everyday cleaning wipe the AX-Synth with a soft, dry cloth or 

one that has been slightly dampened with water. To remove stub-
born dirt, use a mild, non-abrasive detergent. Afterwards, be sure 
to wipe the instrument thoroughly with a soft, dry cloth.

• Never use benzene, thinners, alcohol or solvents of any kind, to 

avoid the possibility of discoloration and/or deformation.

 

• Please be aware that all data contained in the instrument’s mem-

ory may be lost when it is sent for repairs. Important data should 
always be backed up using the Bulk Dump function (see p. 29). In 
certain cases (such as when circuitry related to memory itself is 
out of order), we regret that it may not be possible to restore the 
data. Roland assumes no liability concerning such loss of data.

 

• Please be aware that the contents of memory can be irretrievably 

lost as a result of a malfunction, or the improper operation of the 
unit. To protect yourself against the risk of losing important data, 
we recommend that you periodically save a backup copy of impor-
tant data you have stored in the unit's memory (see p. 29).

• Unfortunately, it may be impossible to restore the contents of data 

that was stored in the AX-Synth’s memory once it has been lost. 
Roland Europe assumes no liability concerning such loss of data.

• Use a reasonable amount of care when using the AX-Synth’s but-

tons, sliders, or other controls; and when using its jacks and con-
nectors. Rough handling can lead to malfunctions.

• When connecting/disconnecting all cables, grasp the connector 

itself—never pull on the cable. This way you will avoid causing 
shorts, or damage to the cable’s internal elements.

• To avoid disturbing your neighbors, try to keep the AX-Synth’s vol-

ume at reasonable levels. You may prefer to use headphones, so 
you do not need to be concerned about those around you (espe-
cially when it is late at night).

• When you need to transport the unit, package it in the box 

(including padding) that it came in, if possible. Otherwise, you will 
need to use equivalent packaging materials.

• The usable range of D Beam controller will become extremely small 

when used under strong direct sunlight. Please be aware of this 
when using the D Beam controller outside.

• Use a reasonable amount of care when using the instrument’s 

buttons, other controls, and jacks/connectors. Rough handling can 
lead to malfunctions. 

• Never strike or apply strong pressure to the display.

 

• Avoid touching or scratching the shiny underside (encoded sur-

face) of the CD-ROM. Damaged or dirty CD-ROM discs may not be 
read properly. Keep your discs clean using a commercially available 
CD cleaner.

 

• Never use alkaline or zinc-carbon batteries.

• The temperature range for use of the batteries depends on the 

battery type being used. Please see the documentation that came 
with the batteries.

• Do not use or store batteries at high temperature, such as in 

strong direct sunlight, in cars during hot weather or directly in 
front of heaters. This may cause battery fluid leakage, impaired 
performance and shorten the batteries’ service life.

• Do not splash fresh or saltwater on a battery or allow the termi-

nals to become damp. This may cause heat generation and forma-
tion of rust on the battery and its terminals.

• If newly purchased batteries exhibit rust, generate heat or seem 

abnormal in any other way, do not use them. Take them back to 
your dealer.

• Keep the batteries out of reach of babies or small children.

 

AX-Synth_e2  Page 6  Monday, October 12, 2009  3:41 PM