Roland C-200 Manuale Utente
37
Additional Convenient Functionality <Advanced Operation>
If necessary, you can erase all settings you have saved inside the C-200 and instead load the settings the C-200 contained when
you first bought it.
you first bought it.
The following procedure will erase all settings you have
made up to this point.
made up to this point.
1.
While holding down the [Function] piston, press the
[Memory Piston].
[Memory Piston].
The [Function] piston and [Memory Piston] start flash-
ing.
ing.
2.
Release the [Function] piston and [Memory Piston].
Be sure to proceed with step (3) within ±10 seconds. If
you wait longer, the [Function] piston and [Memory Pis-
ton] go dark. After that, you need to return to step (1) if
you still want to load the factory settings.
you wait longer, the [Function] piston and [Memory Pis-
ton] go dark. After that, you need to return to step (1) if
you still want to load the factory settings.
3.
While holding down the lower part of the [SUBBASS
16] tilt tab, press the [Lute] piston.
16] tilt tab, press the [Lute] piston.
The [Lute] piston starts flashing.
4.
Wait until the [Function] piston, [Memory Piston] and
[Lute] piston go dark.
[Lute] piston go dark.
5.
Switch off the C-200, wait a few seconds, then switch it
back on again to use the factory settings.
back on again to use the factory settings.
Loading the factory settings
C-200_e.book Page 37 Monday, April 4, 2011 5:22 PM