Roland AT800 Manuale Utente
22
Before You Start Playing
1.
First, make sure that the [Power On] switch at
the panel’s left side is OFF (not pushed in).
the panel’s left side is OFF (not pushed in).
fig. 00-27.eps,fig.00-27-2.eps
2.
Connect the supplied power cord to the AC
Inlet connector, then plug the other end into an
AC outlet.
Inlet connector, then plug the other end into an
AC outlet.
Only use the power cord supplied with this instrument.
Whenever you do not intend to use the instrument for
extended periods of time, pull out the power cord from the
AC outlet.
extended periods of time, pull out the power cord from the
AC outlet.
Once the connections have been completed, turn on or off
power to your various devices in the order specified. By
turning on or off devices in the wrong order, you risk
causing malfunction and/or damage to speakers and other
devices.
power to your various devices in the order specified. By
turning on or off devices in the wrong order, you risk
causing malfunction and/or damage to speakers and other
devices.
1.
Make sure of the following before the power is
turned on.
turned on.
• Is the power cord correctly connected to the AC inlet?
• Is the power cord correctly connected to the AC outlet?
• Is the [Master Volume] slider (located at the left of the
Lower Keyboard) set to the Min (minimum) position?
fig.00-26.eps
2.
Press the [Power On] switch to turn on the
power.
power.
fig. 00-27.eps, fig.00-27-3.eps
The main screen will appear in the display.
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
interval (a few seconds) after power up is required before
the unit will operate normally.
Connecting the Power Cord
OFF
Upper position
Power Cord
AC Outlet
NOTE
NOTE
Turning the Power On and Off
Turning On the Power
NOTE
ON
Lower position
Main Screen
NOTE
AT-800_e.book 22 ページ ２００８年１０月１５日 水曜日 午前９時３７分