Roland RG-3F Manuale Utente

 

Getting Ready

 

fig.ACPdlConnect.eps

 

For the RG-1F: 

Attach the cord clamps (with screws) to locations D, E, and F 

shown below, and use them to fasten the cable.

For the RG-3F: 

Attach cord clamps (with double-sided tape) to locations D, 

E, and F (recommended) shown below, and use them to 

fasten the cable.

 

fig.CordClamp_e.eps

 

941

 

on power to your various devices in the order specified. 

By turning on devices in the wrong order, you risk 

causing malfunction and/or damage to speakers and 

other devices.

 

943

 

Always make sure to have the volume level turned 

down before switching on power. Even with the volume 

all the way down, you may still hear some sound when 

the power is switched on, but this is normal, and does 

not indicate a malfunction.

 

The power will turn on, and the front panel display will show 

the following.

 

fig.d-PowerOn.eps

 

After a short while, sound will be heard when you play the 

keyboard. Use the [Volume] knob to adjust the volume.

 

942

 

This unit is equipped with a protection circuit. A brief 

interval (a few seconds) after power up is required 

before the unit will operate normally.

 

The front panel display will go dark, and the power will turn 

off.

 

945

 

If you need to turn off the power completely, first turn 

off the [Power] switch, then unplug the power cord 

 

Connecting the Pedal Cord and Power Cord

 

Turning the Power On/Off

RG-1F3F_e.book 19 ページ ２０１０年１月１９日　火曜日　午前９時１分