Roland AT15 Manuale Utente

Pagina di 120
 
51
 
Using the Registration Buttons
 
The AT-15 allows you to store sound settings and panel settings such as 8 in 
the Registration buttons. There are a total of 8 Registration buttons, and one 
set of panel settings can be stored in each, allowing you to register a total of 
8 different panel settings. Each set of panel settings that has been stored in a 
Registration button is called a “Registration.”
This provides a convenient way to change large numbers of panel settings 
during a performance, or to recall a complex panel setting.
 
fig.07-01
 
Storing Registrations
1.
 
Make all the panel settings that you wish to store.
 
2.
 
While holding down the [Write] button, press one of the 
Registration [1] – [8] buttons.
 
The panel settings will be stored in the selected Registration button.
6
Write
2
3
4
5
7
8
1
Manual
Settings that have been 
stored to Registration [1]–
[8] buttons are remembered 
even if the power is turned 
off. If you wish to restore 
the settings stored in the 
Registration buttons to 
their factory settings, use 
the “Factory Reset” 
operation (p. 17).
With the settings of 
Registration [1] – [8] 
buttons considered as one 
set, a single floppy disk can 
store up to 99 sets of data 
(p. 56).
For details on the settings 
that are stored in a 
Registration, refer to 
“Settings That Are Stored 
in the Registration Buttons” 
(p. 108).
AT-15_e.book 51 ページ 2005年1月21日 金曜日 午後8時14分