Roland RP201 Manuale Utente
16
Before You Play
1.
Connect the pedal cord to the Pedal connector on the
rear panel of RP201.
Plug the pedal cable all the way into the Pedal connector.
fig.PedalCord.eps
1.
Connect the supplied AC adaptor and power cord.
fig.ACAdpt01.eps
932
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.
The indicator will light when you plug the AC adaptor into an
AC outlet.
Depending on your region, the included power cord may differ
from the one shown above.
2.
Connect the AC adaptor to the DC In jack on the rear
panel.
fig.ACAdpt02.eps
Take care not to pull the cord with excessive force, or strain it.
Doing so may damage or break the cord.
3.
Plug the Power cord into a power outlet.
008c
Be sure to use only the AC adaptor supplied with the unit. Also,
make sure the line voltage at the installation matches the input
voltage specified on the AC adaptor’s body. Other AC adaptors
may use a different polarity, or be designed for a different
voltage, so their use could result in damage, malfunction, or
electric shock
927
Depending on the circumstances of a particular setup, you may
experience a discomforting sensation, or perceive that the
surface feels gritty to the touch when you touch this device.
This is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned about this,
connect the ground terminal (see figure) with an external
ground. When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you are
unsure of the connection method, contact the nearest Roland
Service Center, or an authorized Roland distributor, as listed on
the “Information” page.
Unsuitable places for connection
•
Water pipes (may result in shock or electrocution)
•
Gas pipes (may result in fire or explosion)
•
Telephone-line ground or lightning rod (may be dangerous
in the event of lightning)
in the event of lightning)
4.
If necessary, use the coated clip to secure the pedal cord
and AC adaptor cord.
Even if the cords have been secured, they may be damaged or
broken if excessive force is applied.
Getting Ready to Play
Connecting the Pedal Cord
Connecting the AC Adaptor
Indicator
To AC outlet
AC adaptor
Power cord
Ground terminal
Coated clip
RP-201_e.book 16 ページ ２００９年１１月２０日 金曜日 午後２時３分