Roland 04672434 Manuale Utente
53
Chapter 5 Using MIDI
Chapter 5
MIDI Omni Mode
When set to MIDI Omni mode, the VB-99 receives messages on all
MIDI channels, regardless of the MIDI channel settings. You can use
Omni mode whenever you do not need to use specific MIDI
channels in controlling the VB-99.
MIDI channels, regardless of the MIDI channel settings. You can use
Omni mode whenever you do not need to use specific MIDI
channels in controlling the VB-99.
1.
2.
Press PAGE [
] to display Page 1.
3.
Set Omni mode on or off with [F2] or the F2
knob.
knob.
Even with Omni mode set to ON, the only Exclusive
messages received will be those carrying the Device ID
set for Device ID.
messages received will be those carrying the Device ID
set for Device ID.
Omni mode is set to ON at the factory.
MIDI Device ID
This sets the Device ID to be used for the transmission and reception
of Exclusive messages.
of Exclusive messages.
Device ID is set to 1 at the factory.
1.
2.
Press PAGE [
] to display Page 1.
3.
Rotate the F3 knob to set the Device ID (1–32).
SYNC CLOCK
You can synchronize the VB-99 to the MIDI Clock (tempo)
transmitted from a MIDI sequencer or other external MIDI device.
transmitted from a MIDI sequencer or other external MIDI device.
1.
2.
Press PAGE [
] to display Page 1.
3.
Use [F6] (SELECT) or the F6 knob to select the
MIDI Clock to use as the tempo reference.
MIDI Clock to use as the tempo reference.
For detailed information on the parameters that can be
set, refer to
set, refer to
MIDI ROUTING
Set the VB-99’s control signal path.
The VB-99 features three types of connectors for data input and
output: the MIDI connectors (IN/OUT), a USB connector, and the
RRC2 IN connector. When connecting the VB-99 to devices other
than the FC-300, you need to consider the routing of the control
signals.
output: the MIDI connectors (IN/OUT), a USB connector, and the
RRC2 IN connector. When connecting the VB-99 to devices other
than the FC-300, you need to consider the routing of the control
signals.
Check the display as you set the necessary connections.
You can make the settings for MIDI IN and OUT on Page 2, for the
USB connector on Page 3, and for the RRC2 IN connector on Page 4.
USB connector on Page 3, and for the RRC2 IN connector on Page 4.
1.
2.
Press PAGE [
] [
] to display Pages 2–4.
3.
Set the connections with [F1]–[F3] or the F1–
F3 knobs.
F3 knobs.
VB-99_e.book 53 ページ ２００８年８月１８日 月曜日 午後１時１０分