Euphonix 840-07591-04 Manuale Utente

Euphonix System 5 Installation Guide

 

System 5 Components

35

AES Sync In (3-pin Lemo Female): The DF64 Digital Frame clocks to the signal at this 
port when the sync source is set to AES Sync. Connect this port to a digital sync reference.

AES Sync Out (3-pin Lemo Male): This signal is active regardless of the selected sync 
source.

Word In (BNC): The DF64 clocks to the signal at this port when the sync source is set to 
Word Clock. Connect this port to a digital sync reference.

Word Out (BNC): This signal is active regardless of selected sync source.

IEEE 1394 ports (2): High speed communication interface to the PC253d Digital Pilot 
Computer. This interface carries real-time control and metering data between the PC253d 
and the DF64. Connect either port to any of the IEEE 1394 ports on the dedicated PC253d 
for this frame via firewire (provided). 

MADI In (4) and MADI Out (4) (8 BNC): Digital audio in and outs. See the MADI Hookup 
diagrams (Figure 2-9 and Figure 2-8) for details on these connections.

 This card has no connections.

The System 5 Console consists of several modular components: the CM401 and CM402 
(console center section), the CM408 (contains eight physical faders and controls), the 
CM403 (contains the joystick panner panel and film monitor panel), and the CM409HTP 
Track Panner Module. Each component has the following connections:

Power Connector (IEC): Accepts standard IEC power cord (provided). An autoranging 
switching supply accepts voltages between 100–240 VAC, 50–60 Hz.

Network Port (RJ45): Connect to EuCon Network Hub via RJ45 through the console 
ethernet harness (provided).

Expansion Port (DB25): Active on the CM401 only. Connect talkback switches here.