Euphonix 840-08758-02 Manuale Utente
Euphonix Max Air Control Surface Manual
10
LED Test
LED loop
This switch cycles through all the LED colors.
Color Toggle
These switches light all the LEDs of each color: green, red, yellow, orange
All LEDS
This turns all LEDs on.
NOTE: To avoid overheating, the module should not be left with All LEDS on for more
than 5 minutes.
Fader Test
All Fader Up
All faders all the way up.
All Fader Down
All faders all the way down.
Fader Echo Test
All faders follow the one fader touched.
Fader Loop Test with Speed Control
All faders cycle up and down at the speed determined by the speed control knob. This
fader cycle test times out after 5 minutes to protect the faders from burning out.
fader cycle test times out after 5 minutes to protect the faders from burning out.
Backstop PFL Switch Test
The Backstop PFL display lights up when a fader is pulled back to enable its backstop
PFL switch. This mode is always active.
PFL switch. This mode is always active.
Fader I/O
•
Fader Write value display
Any value written to a fader is displayed in its designated fader write intelligent
display. This mode is always active in fader test mode.
Any value written to a fader is displayed in its designated fader write intelligent
display. This mode is always active in fader test mode.
•
Fader Read value display
All faders are continuously read and the read value is displayed in its designat-
ed fader read intelligent display.
All faders are continuously read and the read value is displayed in its designat-
ed fader read intelligent display.