Behringer 1204FX Manuale Utente

XENYX 1204FX/1204 User Manual

The packaging of your mixing console contains two 19" rack mount wings which 
can be installed on the side panels of the console.

Before you can attach the rack mount wings to the mixing console, you need to 
remove the screws holding the left and right side panels. Use these screws to 
fasten the two wings onto the console, being careful to note that each wing fits 
a specific side. With the rack mount wings installed, you can mount the mixing 
console in a commercially available 19" rack. Be sure to allow for proper air flow 
around the unit, and do not place the mixing console close to radiators or power 
amps, so as to avoid overheating.

You will need a large number of cables for the various connections to and from the 
console. The illustrations below show the wiring of these cables. Be sure to use 
only high-grade cables.

Fig. 4.1: ¼" TS connector for foot switch

Please use commercial RCA cables to wire the 2-track inputs and outputs.

You can, of course, also connect unbalanced devices to the balanced input/outputs. 
Use either mono plugs, or ensure that ring and sleeve are bridged inside the stereo 
plug (or pins 1 & 3 in the case of XLR connectors).

For unbalanced use, pin 1 and pin 3 have to be bridged

1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)

1

2

3

1

2

3

Fig. 4.2: XLR connections

Fig. 4.3: ¼" TS connector