Pioneer cdj-900nxs Manuale Utente

Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After 
you have finished reading the instructions, put them away in a safe place for future reference.
In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. 
However the method of connecting and operating the unit is the same.

This equipment is not waterproof. To prevent a fire or 
shock hazard, do not place any container filled with 
liquid near this equipment (such as a vase or flower 
pot) or expose it to dripping, splashing, rain or 
moisture.

To prevent a fire hazard, do not place any naked flame 
sources (such as a lighted candle) on the equipment.

Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH 
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in 
locations exposed to high humidity or direct sunlight (or 
strong artificial light).

This product satisfies electromagnetic noise 
regulations when it is connected to other equipment 
through shielded cables and connectors.
Use only the furnished accessory connecting cables.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used 

electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to 

designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential 

negative effects on the environment and human health.

The 

  switch on this unit will not completely shut off 

all power from the AC outlet. Since the power cord 
serves as the main disconnect device for the unit, 
you will need to unplug it from the AC outlet to shut 
down all power. Therefore, make sure the unit has 
been installed so that the power cord can be easily 
unplugged from the AC outlet in case of an accident. 
To avoid fire hazard, the power cord should also be 
unplugged from the AC outlet when left unused for a 
long period of time (for example, when on vacation).

When using this product, confirm the safety 
information shown on the bottom of the unit.

This product is a class 1 laser product classified 
under the Safety of laser products, IEC 60825-1:2007.

CLASS 1 LASER PRODUCT

Handle the power cord by the plug. Do not pull out the 
plug by tugging the cord and never touch the power 
cord when your hands are wet as this could cause a 
short circuit or electric shock. Do not place the unit, a 
piece of furniture, etc., on the power cord, or pinch the 
cord. Never make a knot in the cord or tie it with other 
cords. The power cords should be routed such that they 
are not likely to be stepped on. A damaged power cord 
can cause a fire or give you an electrical shock. Check 
the power cord once in a while. When you find it 
damaged, ask your nearest PIONEER authorized 
service center or your dealer for a replacement.

Water droplets (condensation) may form inside the unit 
(on operating parts and lenses) in the winter, for 
example, if the unit is moved from a cold place into a 
warm room or if the temperature in the room in which 
the unit is installed rises suddenly (through heating, 
etc.). The unit will not operate properly and will not be 
playable with condensation inside. Let the unit stand for 
1 to 2 hours at room temperature (though this time 
depends on the conditions of the condensation) without 
turning on the power. The water droplets will evaporate 
and the unit will become playable. Condensation can 
occur in the summer as well if the unit is exposed to the 
direct wind from an air-conditioner, etc. If this happens, 
move the unit to a different location.

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT 
REMOVE COVER (OR BACK). NO USER-SERVICEABLE 
PARTS INSIDE. REFER SERVICING TO QUALIFIED 
SERVICE PERSONNEL.