Tapco MIX10FXP Manuale Utente

These output connections provide 

speaker-level output power from the 
internal power amplifi ers to your passive 
speakers. The peak power output is 500 
watts per channel into 4 ohms.

Only passive loudspeakers should 
be connected to these speaker-
level outputs.

The outputs can be selected with the 

amp mode switch (12) to be either the 
stereo main mix, or the mono main mix on 
output A, and the monitor mix on output B.

Two common types of connector are 

provided for your convenience: Speakons

®

 

and 1/4" TS.

•  Speakon outputs are wired Pin 1+ 

positive (hot) and Pin 1– negative 
(cold).

•  1/4" TS outputs are wired Tip positive, 

and Sleeve negative.

These two types of outputs are wired in 

parallel, and it is possible to use both types 
at once.

The minimum impedance that 
the powered mixer can handle 
is 4 ohms per channel, and we 
recommend that you do not go 

below this. If you are using both output styles 
per channel, make sure each loudspeaker is 
8 ohms impedance or greater.

COLD

HOT

1+

1+

1–

1–

2–

2+

SLEEVE

TIP

TIP

SLEEVE

TIP

SLEEVE

Do not obstruct these ventilation slots, or 

the internal amplifi ers may overheat and 
shut down.

Allow at least six inches of free space 

behind the powered mixer when in use.