Fostex LM16 Manuale Utente
33
Model LM16 [Mixer basics]
You can group channels to group busses for
effective mixing.
Using the channel grouping function, you can
adjust levels of grouped channels using a
single fader while maintaining the balance
between channels.
effective mixing.
Using the channel grouping function, you can
adjust levels of grouped channels using a
single fader while maintaining the balance
between channels.
Channel grouping
By setting the group assign switch (1-2 or 3-
4) of a channel to ON, the channel signal is
sent to group busses 1 and 2 or 3 and 4. A
group buss signal is output from the [GROUP
OUT] jacks.
When the [ASSIGN TO STEREO OUT] switch
above the group fader is set to ON, the group
buss signal is output to the corresponding
stereo buss.
4) of a channel to ON, the channel signal is
sent to group busses 1 and 2 or 3 and 4. A
group buss signal is output from the [GROUP
OUT] jacks.
When the [ASSIGN TO STEREO OUT] switch
above the group fader is set to ON, the group
buss signal is output to the corresponding
stereo buss.
For example, it would be a good idea to as-
sign channels for drums to a group. You can
control the level of drums using the corre-
sponding group fader without altering the
balance.
sign channels for drums to a group. You can
control the level of drums using the corre-
sponding group fader without altering the
balance.
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ST
1-2
3-4
ASSIGN TO
STEREO OUT
GROUP 3, 4
ASSIGN TO
STEREO OUT
GROUP 1, 2
STEREO
STEREO BUS
GROUP 1-2 BUS
GROUP 3-4 BUS
Channels which are assigned
to the stereo buss
to the stereo buss
Channels which are assigned
to the group busses
to the group busses
Assigned to the
stereo buss
stereo buss
• Solo monitor
By setting the [SOLO] switch(es) to ON ( ),
you can solo monitor the corresponding chan-
nel signal(s).
If at least one of the [SOLO] switches is set to
ON, the [SOLO] indicator slowly flashes.
you can solo monitor the corresponding chan-
nel signal(s).
If at least one of the [SOLO] switches is set to
ON, the [SOLO] indicator slowly flashes.
<Note>:
If any of the [SOLO] switches is set to
ON, the solo signal is monitored, while the
signal selected by the [MONITOR SELECT]
switch is interrupted.
signal selected by the [MONITOR SELECT]
switch is interrupted.
You can find the [SOLO] switches on chan-
nels 1 through 16, the effect send, and AUX
sends 1 through 3 (see below).
nels 1 through 16, the effect send, and AUX
sends 1 through 3 (see below).
[SOLO] indicator
[SOLO] switches
[SOLO]
switches