American Dj Flash-2C Dépliant
American DJ
®
LOS ANGELES, CA. 90058 USA • www.americandj.com
Model:
Flash-2C™
SPECIFICATIONS:
Power: 110V/60Hz
Weight: 8 lbs.
Size:
Weight: 8 lbs.
Size:
19” x 3.5” x 5”
Fuse: 15A
T h a n k y o u f o r p u rc h a s i n g t h i s
A m e r i c a n D J ®
p ro d u c t . F o r y o u r
convenience this products ready to be
used, there is no assembly required.
P l e a s e re a d t h e f o l l o w i n g
instructions before installing or using
your new unit.
used, there is no assembly required.
P l e a s e re a d t h e f o l l o w i n g
instructions before installing or using
your new unit.
Operating Instructions:
The American DJ® Flash-2C, flash tube controller is
ideal for mobile DJ’s and club use. One Flash-2C will
control 4 expandable lines of Flash Tubes.
POWER- ON & OFF
1,2,3,4 - ON & OFF for individual lines.
SYNC - All tube flash at the same time
AUTO - Flashes line of tubes one by one
SPEED knob - Controls speed of chase.
RATE knob - Controls rate of pulse (ie. speed
between triggering strobe) of the Flash Tubes.
TRIGGER - starts a flash run when in manual mode
MANUAL - allows you to TRIGGER flash manually.
MODE SELECT - Choose 1 of 4 modes to chase in.
1.
ideal for mobile DJ’s and club use. One Flash-2C will
control 4 expandable lines of Flash Tubes.
POWER- ON & OFF
1,2,3,4 - ON & OFF for individual lines.
SYNC - All tube flash at the same time
AUTO - Flashes line of tubes one by one
SPEED knob - Controls speed of chase.
RATE knob - Controls rate of pulse (ie. speed
between triggering strobe) of the Flash Tubes.
TRIGGER - starts a flash run when in manual mode
MANUAL - allows you to TRIGGER flash manually.
MODE SELECT - Choose 1 of 4 modes to chase in.
1.
Rebound
2. Crossover
3. Reverse
4.
4.
Forward
For service, contact your
American DJ
®
dealer
.
American DJ
®
User Instructions
Flash-2C
™
POWER
ZONE CONTROL
PULSE CONTROL
1
2
3
4
SYNC AUTO
MODE SELECT
FLASH MANUAL
SPEED RATE
AUDIO TRIGGER
SET UP:
Link the Flash Tubes to the Flash-2C™ by inserting tube
connectors into controller sockets on the back of unit.
The maximum length to first Flash Tube™ is 10 ft, any
more and you will have to use a Flash Buffer.
connectors into controller sockets on the back of unit.
The maximum length to first Flash Tube™ is 10 ft, any
more and you will have to use a Flash Buffer.
If you connect more than 30 Flash Tubes in any single
line use a Flash Buffer™ to boost signal.
line use a Flash Buffer™ to boost signal.
At the end of each line connect a Flash-Term™. If you
don’t use one the Flash Tubes will work but not properly.
Plug Flash-2C™ and any Flash Buffer™ into power.
Refer to Operating instructions for use.
don’t use one the Flash Tubes will work but not properly.
Plug Flash-2C™ and any Flash Buffer™ into power.
Refer to Operating instructions for use.
4 CHANNEL FLASH TUBE CONTROLLER
Caution!
Always use appropriate cables and
connectors. Remember to always replace with
same fuses. Always keep controllers dry. Don’t
exceed load and length limitations
same fuses. Always keep controllers dry. Don’t
exceed load and length limitations