AMX NXM-MHS Manuale Utente

Pagina di 48
Product Information - NetLinx Modules
4
NetLinx Master Cards and Modules
Program Port Connections/Wiring
Master Cards are equipped with two Program ports. One is located on the front panel and the other 
is on the rear for easy access. The port on the front panel is a DB-9 (male) connector, and the rear 
port is a 5-pin (male) connector. Use a Programming cable to connect the Program port to your PC's 
COM port to communicate with the Master Card. Then, you can download NetLinx programs to 
the Master Card with the NetLinx Studio software program. Refer to the NetLinx Studio instruction 
manual for programming instructions.
DB-9 Program port (front panel)
The following table shows the front panel DB-9 Program port connector, pinouts, and signals.
5-Pin Program port (rear panel)
The table below lists the pinouts and signals for the rear panel Program port connector.
DB-9 Program Port, Pinouts, and Signals
DB-9 Program Port Connector
Pin
Signal
2
RX
3
TX
5
GND
7
RTS
8
CTS
5-Pin Program Port Pinouts and Signals
Pin
Signal
1
GND
2
RX
3
TX
4
CTS
5
RTS
solder side
1 2 3 4 5
6 7 8 9