Roland PAD-80 Manuale Utente

0–80

This setting cancels “crosstalk,” which means that when you play one pad you hear a sound coming from another 
pad. This can happen when two pads are installed on the same stand. In some cases you can prevent crosstalk by 
increasing the distance between the two mounted pads.

In some cases you can prevent crosstalk by increasing the distance between the two mounted pads.

Crosstalk Example: If you hit the 2/SNARE pad and the 3/HI-HAT also sounds
While striking the 2/SNARE pad, gradually increase the “XTalk Cancel” value for the 3/HI-HAT pad until the 3/HI-HAT 
pad no longer sounds when you hit the 2/SNARE pad. Raise the “Xtalk Cancel” for the pad being used for 3/HI-HAT. 
The 3/HI-HAT pad will be less prone to receive crosstalk from other pads.

0.0–8.0

When a PD-125/120/105/85/80R, PDX-8, PD-9/8/7, CY series pad, VH-11, or RT-10S is connected, you can adjust the 
relation between your playing velocity (force) on the rim/edge and the resulting volume level.

Higher value allows the rim/edge to produce a loud volume even when played softly.

Lower value will keep the rim/edge producing a low volume even when played forcefully.

0.0–8.0

When a PD-125/120/105/85/80R, PDX-8, or RT-10S is connected, you can adjust the sensitivity of the rim response. 
There are some cases that you have a rim sound unexpectedly when you hit the head strongly. You can improve this 
situation with decreasing the value of “Rim Adjust.” When you set the value too small, it might be difficult to play the 
rim sound.

Here’s how to make settings for an optional, external hi-hat control pedal (FD-8 or VH-11).

Ú

Ú

HH PEDAL (p . 16) .

The PAD SETTING-HH PEDAL screen appears.

Pedal Calibration Indicator
If Pad Type is set to “VH-11,” a pedal calibration indicator for 

the VH-11 is shown.
For types other than the VH-11, the indication will be for 

the FD-8.

[Knob 3] (–/+) edits the value.

-10–+10

Adjusts the sensitivity for playing foot-close or foot-splash notes.

Positive (“+”) settings allow louder sounds to be produced even when you step lightly on the pedal.

*  If you connect an external hi-hat control pedal, set the “HH CTRL” (p . 32) parameter of the hi-hat Inst to “PEDAL .”

VH-11 Offset Adjustment

If you’re using a V-hi-hat (VH-11: sold separately), make adjustments by turning the VH-11’s VH offset adjustment screw while 

watching the indicator shown in the right side of the screen.

Adjust so that this 

symbol is shown in the 

indicator

VH offset adjustment screw

If the closed hi-hat sound is difficult to attain, rotate the VH offset adjustment screw towards “CLOSE.” If the open hi-hat 

sound is difficult to attain, rotate the screw towards “OPEN.” If the sound cuts off when you hit the hi-hat forcefully, rotate 

the VH Offset adjustment screw towards “OPEN.”