Snapper ESV25650B Manuale Utente

 

Read, understand and follow instructions and 

warnings in this manual and on the machine, engine 

and attachments before operating. Know the controls 

and the proper use of the machine before starting. 

Make the following checks and perform the service 

required before each start-up. 

2.1.1.  Check guards, deflectors and covers to make 

sure all are in place and securely tightened. 

2.1.2.  Carefully inspect machine for loose, missing, 

damaged or worn components. Repair or replace as 

necessary before operating the machine. 

2.1.3. Carefully inspect the debris bag and bag 

adapter for wear and deterioration. IMPORTANT – 

open top of bag to inspect interior of bag and the 

discharge deflector end of the bag adapter. Replace 

bag and bag adapter if they display signs of 

deterioration. The debris bag must be attached to the 

bag adapter, the bag adapter mounted onto the 

machine, and the zippered top fully closed before 

starting engine. The top rear corners of the bag are 

attached to the handles by using the cloth straps 

located near the top of the bag. See Figures 2.2 and 

2.3. 

2.1.4.  Check engine oil and add oil as needed to 

bring level up to the FULL mark. Refer to engine 

owner’s manual for oil specifications. See Figure 2.1.  

 

 

2.1.5.  Check engine speed control to insure it 

works freely. 

2.1.6. Clean exterior surfaces of machine and 

engine of any accumulation of dirt, grass, oil, etc.  

Keep engine air intake screen and cooling fins clear 

at all times. 

2.1.7.  Add fuel to tank after pushing the machine 

outside where fumes can dissipate.  Make sure fuel 

filler cap is tight after refueling.  Refer to engine 

owner’s manual for fuel specifications. 

2.1.8.  Adjust height of vacuum inlet. Lift up on 

handles. Squeeze height control lever against handle. 

Raise or lower handles until desired inlet height has 

been obtained. Release control lever. See Figure 2.4. 

 

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

FIGURE 2.4