GE DEH-211 Manuale Utente
54
••••
EPM Device- Special Considerations
CIMPLICITY PMCS Read-This-Book-First
Adding Software Nodes
Software nodes identify the various software components in the network. Stationless
Secondary nodes, although they are physically separate computers, do not run a
Communications Server and are therefore not considered Workstations by Network
Builder. Instead, Stationless Secondary nodes appear in the network diagram as
software nodes under the Primary Workstation. Full Station Secondary nodes appear
as Workstations because they do run an instance of the Communications Server.
Secondary nodes, although they are physically separate computers, do not run a
Communications Server and are therefore not considered Workstations by Network
Builder. Instead, Stationless Secondary nodes appear in the network diagram as
software nodes under the Primary Workstation. Full Station Secondary nodes appear
as Workstations because they do run an instance of the Communications Server.
Acknowledging the Add Workstation dialog brings up a message box asking if you
want to set up the default software nodes – choose Yes to display the software nodes
dialog (shown below). Select only ION Designer and Pegasys ION_Link DDE Server
as shown, then click OK to proceed. The other options are not supported in PMCS
6.9.
want to set up the default software nodes – choose Yes to display the software nodes
dialog (shown below). Select only ION Designer and Pegasys ION_Link DDE Server
as shown, then click OK to proceed. The other options are not supported in PMCS
6.9.