Pico Macom M7100 Manuale Utente

 

This section describes the buttons, keys and rotary knobs used to control the M7100

IP

 Series Mobile Scan 

and System Model radios.  All functions and controls of the Scan radio operate the same as the 
corresponding functions and controls on the System radio.  The Scan radio is equipped with a 4-button 
keypad and the System radio is equipped with a 16-button keypad. 

Many of the control buttons and keys have been or can be programmed to have a primary function and a 
secondary function.  The SCAN button can be programmed (as a secondary function) to toggle the keypad 
keys between their primary function and their secondary function. 

 

 

This rotary knob powers the radio ON and OFF and adjusts the receiver volume. Rotating
the control clockwise out of detent applies power to the radio.  A single alert tone sounds
(if enabled through programming) to indicate the radio is operational.  

Rotating the control clockwise increases the volume level.  Minimum volume levels can be programmed 
into the radio to prevent missed calls due to a low volume setting.  While adjusting the volume, the display 
will briefly indicate the volume level (i.e. VOL = 31).  The volume range is from a minimum level of zero 
(displayed as OFF in the display) up to 31, which is the loudest level. 

 

 

This rotary switch selects the systems or groups/channels, depending upon programming.
This 16-position rotary switch has no stop or detent.  See SYSTEM/GROUP/CHANNEL 
SELECTION section for more details.  

 

The primary function of this rocker type button is to scroll through the System list or the
Group/Channel list depending upon programming.  The secondary function is to increment or

decrement items within a list (phone list for example).  Press 

,

to scroll in increasing order 

and press 

.

 to scroll in decreasing order.  To auto-ramp, press and hold the button.  

 

 

The primary function of this button is to toggle scan operation ON and OFF.  When the radio 
is scanning, the SCAN LED is on and all groups or channels in the scan list of the currently
selected systems are scanned.  

The secondary function of the SCAN button is to toggle the keypad buttons between their primary function 
and their secondary function.