Grizzly G0758 Manuale Utente
Model G0758 (Mfd. Since 2/14)
-29-
Table and Column Ways
Lube Type .. Model SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Regular lubrication will ensure mill/drill performs
at its highest potential.
at its highest potential.
Regularly wipe table and
column ways with recommended lubrication, then
move components back and forth several times to
ensure smooth movements (see
move components back and forth several times to
ensure smooth movements (see
Figures 34–36).
Z-Axis Leadscrews
Lube Type ..Model T23964 or NLGI#2 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ....... 120 hrs. of Operation
Lube Amount ........................................Thin Coat
Lubrication Frequency ....... 120 hrs. of Operation
To lubricate Z-axis leadscrew:
1. DISCONNECT MACHINE FROM POWER!
2. Lower headstock as far as you can without
contacting spindle to table surface.
3. Use mineral spirits and a brush to clean as
much existing grease and debris off of Z-axis
leadscrew shown in
leadscrew shown in
Figure 37 as possible.
Allow leadscrew to dry.
4. Using a brush, apply NLGI#2 grease to
exposed leadscrew threads, then move head-
stock through its full range of motion several
times to disperse grease along full length of
leadscrew.
stock through its full range of motion several
times to disperse grease along full length of
leadscrew.
Figure 35. Y-axis way lubrication points.
Y-Axis Ways
Figure 36. X-axis lubrication points.
X-Axis Ways
Figure 37.
Z-axis leadscrew lubrication point.
Z-Axis
Leadscrew
Figure 34. Z-axis way lubrication points.
Z-Axis Ways
(1 of 2)