Grizzly G1126 Manuale Utente
-
7 -
- 7 -
IX. ASSEMBLY
Figure 2
The Model G1126 is largely pre-assembled at the factory, so very little actual assembly is required.
The motor is already mounted and all wiring is in place. The remaining parts which require assem-
bly are:
The motor is already mounted and all wiring is in place. The remaining parts which require assem-
bly are:
A. Power Feed
B. Handwheels
C. Cutter / Arbor Installation
B. Handwheels
C. Cutter / Arbor Installation
The necessary assembly can be accomplished with a few hand tools. You’ll need a 12mm wrench,
a 14mm wrench, metric Allen wrenches and a Phillips head screwdriver. An adjustable wrench and
a metric socket set are helpful, but not essential, for assembly.
a 14mm wrench, metric Allen wrenches and a Phillips head screwdriver. An adjustable wrench and
a metric socket set are helpful, but not essential, for assembly.
Spindle Height
Adjustment
Lever Lock
Front-to-Back
Adjustment
Handwheel
Power
Feed
Column
Adjustment
Quill
Return
Spring
Side-to-Side
Adjustment
Handwheel
Speed
Selectors
Power / Direction
Switch
Spindle Height
Adjustment
Wheel
Micro Height
Adjustment
Wheel
Head Swivel
Adjustment
Bolts
Power Feed
Stops
A. POWER FEED
The Model G1126 features a 110V auto-feed mechanism, allowing hands-free side-to-side passes
while milling. The variable-speed feed control ensures greater consistency when milling large, flat
surfaces. To install the auto-feed mechanism:
while milling. The variable-speed feed control ensures greater consistency when milling large, flat
surfaces. To install the auto-feed mechanism:
1.
Attach the drive gear to the end of the table screw, using the attached setscrew. The gear cou-
plers will lock in place with the matching coupler on the end of the table screw.
plers will lock in place with the matching coupler on the end of the table screw.
2.
Attach the clamping bracket provided with the auto-feed mechanism, as shown in Figure 3.
Gib Locks