Jet Tools DC-1100G Manuale Utente

 

12

1.  Place the ring over the top of the plastic bag and 

fold over the bag approximately three inches, 
Figure 9. 

 

 

 

 

 

 

 

2.  Insert the snap ring (A, Fig. 10) of the collector 

bag into the bottom of the housing at an angle.   

3.  Pull down on the ring to make sure it “seats” in the 

housing.   

Note:  make sure the snap ring “snaps” into place 
in the housing, and also that the plastic bag  
hangs down approximately 3” so that there are no 
air leaks. 

 

 

 

 

 

 

 

4.  Mount the handle onto the canister filter with two 

M10 hex nuts, two M10 flat washers, and a M10 
lock washer (Figure 11). 

5.  Mount the canister filter on top of the collector 

housing (A, Fig. 5) and tighten the knobs on the 
canister filter (Figure 11).