Husqvarna FS 700 EX Manuale Utente

 

English -

 

 

 

9

 

and the trolley feed lever is in the neutral position or 
the machine is not voltage fed, this position acts as a 
parking brake.

If the foot lever is switched to the other position no 
gear is engaged and the machine is easy to move. Use 
this position when the machine needs to be 
transported over long distances.

 

The user can use the hose holder to prevent hoses 
and cables trailing behind the machine. These will lie 
to the side of the machine instead.

 

Can be fitted on either the right or left-hand side of the 
machine as required. The guard can be secured in the 
upright position by using the lever on the rear edge of 
the guard.

 

The machine is equipped with a folding splash guard to 
minimise water spray and dirtying. When the machine 
is transported over long distances the splash guard 
should be folded up and secured using the spring on 
the blade guard. The splash guard should always be 
folded down when cutting.

 

The blade flange fits on either side of the machine to 
allow the blade to be easily fitted on both sides of the 
machine 

The blade flange should be covered with the blade 
flange guard when a blade is not fitted The blade 
flange guard is fitted on the right-hand side on delivery.

The machine is supplied with a standard blade flange. 
A flush cutting blade flange can be purchased as an 
option. Fit the blade on the flush cutting blade flange 
when the cut is to be made next to a wall. A special 
flush cutting blade guard must be used when cutting 
flush.

 

The height of the handle can be adjusted by loosening 
these two screws to the most suitable height.

 

Adjust this screw to tension the drive belt.