Draper 60607 Manuale Utente

Fig.1.

Fig.2.

Fig.3.

(A) 

(B) 

(D) 

(C) 

(L) 

(K) 

Fig.4.

(G) 

(F) 

Connect the compressor to the power supply. 
Always turn on and off by the appropriate switch.

TURNING ON AND OFF (DA6/200/DA6/201, 
DA25/180, DA25/200  - NOT DA200): THE ON/
OFF SWITCH.

(A) Fig.1. is located on the top of the pressure 
switch box.

These compressors are controlled by a pressure 
switch assembly (B) Fig.2. which automatically 
cuts off the power supply to the motor when 
the upper limit is reached and restarts the 
compressor automatically when the pressure 
drops below the minimum.

TURNING ON AND OFF (DA200 ONLY):

This compressor is operated by a manual 
on/off switch (F) Fig.4. and NOT by an 
automatic pressure switch as fitted to the other 
compressors shown in this booklet.

WARNING (DA6/200/DA6/201, DA25/180, 
DA25/200):

The pressure switch is set at the factory and the 
compressor is also fitted with a safety valve in 
the event of the pressure switch not functioning 
correctly.

DA25/180, DA25/200

Close the air outlet valve (C) Fig.2. and adjust 
pressure by turning the knob on the pressure 
regulator valve (D) Fig.2. clockwise to increase 
pressure. Should it be necessary to decrease 
pressure open the the air outlet valve (C) Fig.2. 
slightly and then turn the pressure regulator 
valve knob (D) anticlockwise, re-close air outlet 
valve (C).

DA200

This compressor is fitted with a pressure 
regulator unit (G) Fig.4. so the pressure may be 
regulated as necessary. To increase the pressure 
turn the knob clockwise, to decrease the 
pressure turn the knob anticlockwise.

DA6/200

Close the air outlet valve (K) Fig.3. and adjust 
pressure by turning the knob on the pressure 
regulator valve (L) Fig.3. clockwise to increase 
pressure. Should it be necessary to decrease 
pressure open the the air outlet valve (K) Fig.3. 
slightly and then turn the pressure regulator 
valve knob anticlockwise, re-close air outlet 
valve.