Multiquip MVC88VTH Manuale Utente

Pagina di 76
page 18 — MVC88VTH/VTHW pLaTe COMpaCTOR • OpeRaTiOn and paRTs ManuaL — ReV. #2 (12/09/13) 
This section is intended to assist the operator with the 
initial start-up of the compactor. It is extremely important 
that this section be read carefully before attempting to use 
the compactor in the field.
sTaRTing THe engine
1.  Place the engine fuel valve lever (Figure 12) to the 
On” position.
Figure 12. Engine Fuel Valve Lever (ON Position)
2.  Move the throttle lever (Figure 13) away from the 
idle 
position, about 1/3 of the way toward the 
run position.
Figure 13. Throttle Lever (1/3 Start Position)
  CauTiOn
dO nOT attempt to operate the compactor 
until the Safety, General Information and 
Inspection sections of this manual have 
been 
read and thoroughly understood. 
STARTUp
3.  Place the
 choke lever (Figure 14) in the “CLOsed” 
position if starting a cold engine.
Figure 14. Choke Lever (Closed)
4.  Place the engine ON/OFF switch (Figure 15) in the 
"
On" position.
Figure 15. Engine ON/OFF Switch (ON Position)
5.  Grasp the starter grip (Figure 16) and slowly pull it 
out. The resistance becomes the hardest at a certain 
position, corresponding the compression point. Rewind 
the rope a little from that point and pull out sharply.
CLOSED
CHOKE LEVER
 NOTICE
The 
CLOsed position of the choke lever enriches the 
fuel mixture for starting a 
COLd engine. The Open 
position provides the correct fuel mixture for normal 
operation after starting, and for restarting a warm 
engine.