Vector VEC256 Manuale Utente

99

This 12 Volt DC compressor is the ultimate compressor for all Vehicles, Trailer Tires 

and recreational inflatables. Three different sized nozzles are supplied.
IMPORTANT: Read Safety Instructions Carefully To Avoid Possible Injury 

                        Or Property Damage.
WARNINGS: The compressor is capable of inflating to 260 pounds per   

square inch (PSI) pressure (approximately 18 kg/cm).  To avoid over- 

 

inflation, carefully follow instructions on articles to be inflated.  Never  

 

exceed recommended pressures.  Bursting articles can cause serious  

 

injury. Always check pressure with the pressure gauge.  Never leave  

 

compressor unattended while in use. Allow unit to cool for five minutes    

after10 minutes of continuous operation.

6.1  TIRE INFLATION OR PRODUCTS WITH A VALVE STEM

1. Place connector (chuck) on valve stem.

2. Push connector toward valve stem and close thumb latch.

3.  Make  sure  connector  is  pushed  on  to  valve  stem  as  far  as  possible  

    before closing thumb latch.

4. Turn on the compressor (for larger items the trigger can be latched).

5. Observe pressure with the pressure gauge.

6. When desired pressure is reached, open thumb latch and remove 

  connector from valve stem.

7. Turn OFF compressor power switch.

IMPORTANT:    Always  leave  the  tire  chuck  thumb  latch  in  the  open  

                       position when storing unit.

 

6.2  INFLATE OTHER ARTICLES (WITHOUT VALVE STEM)

Inflation of other than tires requires use of one of the nozzles (adapters). A 

nozzle can be attached to the tire chuck or it can directly be connected to 

the compressors outlet if the hose is removed.
A nozzle can be attached to the tire chuck. Open the nozzle hatch cover 

and remove the required nozzle. Close the nozzle hatch cover. Place the tire 

chuck over the nozzle fitting and secure by moving the chuck thumb latch so 

it is parallel with the hose. Make sure the nozzle is clean and secure before 

turning on the compressor. After use, release the nozzle from the chuck by 

lifting the latch. Return the nozzle to the nozzle hatch.
A nozzle can also be directly attached to the compressor outlet if the hose 

is not required.