Roland EGX-350 Manuale Utente
4-9 Performing Engraving
78
Chapter 4 Engraving
Executing Repeated Cutting
A single set of cutting data is saved in the machine’s memory until the next set of data is sent from the computer. You
can use this data to repeat the same cutting by operating just the machine.
Note, however, that cutting data that exceeds the machine’s memory capacity (2 MB) cannot be copied.
can use this data to repeat the same cutting by operating just the machine.
Note, however, that cutting data that exceeds the machine’s memory capacity (2 MB) cannot be copied.
Procedure
➊
Send the cutting data from the computer and execute cutting.
➋
Change the workpiece.
☞ P. 54, “Mounting a Workpiece”
➌
Press
.
➍
Use
to select “GO.”
Press
to confirm.
Cutting is performed again using the cutting data used for execution just before.
Operation When Other Items Are Selected
➢ “CANCEL”
This returns you to the original menu without performing cutting again.
➢ “CLEAR”
This deletes the cutting data saved in the machine.