Roland EGX-20 Manuale Utente
15
2 Getting Ready the Software
The setup screen ([Welcome] dialog box) appears for the
next program to install.
Carry out steps through on the previous page.
Install Dr. Engrave and 3D Engrave.
next program to install.
Carry out steps through on the previous page.
Install Dr. Engrave and 3D Engrave.
When installation of 3D Engrave finishes, the [EGX-20
Driver Installation] dialog box appears.
Choose the port for connecting the EGX-20.
The EGX-20 connects to a printer port. If your computer
has a single printer port, select [LPT1:].
Click [OK].
The EGX-20 driver is installed.
Driver Installation] dialog box appears.
Choose the port for connecting the EGX-20.
The EGX-20 connects to a printer port. If your computer
has a single printer port, select [LPT1:].
Click [OK].
The EGX-20 driver is installed.
When installation of the EGX-20 driver finishes, the
[Settings: [EGX-20]] dialog box appears.
Make sure the values are correct, then click [Close].
[Settings: [EGX-20]] dialog box appears.
Make sure the values are correct, then click [Close].
When all installation and setup finishes, a prompt dialog
box appears. Click [Close].
box appears. Click [Close].
When the setup menu screen reappears, click the
button.
button.
Take the CD-ROM out of the CD-ROM drive.
10
11
12
13
14
15
6
9