Datalogic Scanning DX30 Manuale Utente

GRYPHON™ Dx30/Mx30 

 

When single store mode is enabled, if the Gryphon™ Mx30 fails to transmit a code to 
the cradle, it enters a special operating mode that prevents the user from reading 
barcodes. When such operating mode is entered, the trigger no longer enables 
barcode reading but is used to retry transmission itself for the number of attempts 
selected in configuration. Once the transmission is successful the reader returns to 
the standard mode. If transmission is not successful after the number of configured 
attempts, the code is discarded. 
 
Single store may be useful if you often read codes at the limit of the coverage area 
and there is a chance that code transmission can fail. In such case single store 
allows you to move to a more favorable position or location (i.e. closer to the cradle) 
and retry transmission without the necessity of re-reading the code since it is already 
stored in the reader. 
 
Conversely, if single store is disabled, and the user wants to retry transmission, the 
code must be read again, and therefore the attempt must be made from basically the 
same location. If the user gives up, he does not know if the transaction was 
successful. (Actually the transmission could have been successful but the cradle may 
have been unable to acknowledge the message). There are applications in which 
there is no risk of transmission failure. In such cases it may be better to disable single 
store so that the user perceives a more consistent behavior of the trigger in that it 
always corresponds to code reading.