Netcomm NTC-990 Manuale Utente
9.3
How to Configure RIP
RIP (Routing Information Protocol) is used for advertising routes to other routers. Thus all the routes in the
Cellular Router’s routing table will be advertised to other nearby routers. For example, the route for the
Cellular Router’s Ethernet subnet could be advertised to a Router on the PPP interface side so that a
Router on this network will know how to route to a device on the Cellular Router’s Ethernet subnet. You will
have to add the routes appropriately in the Static Routes section – see Adding Static Routes.
Cellular Router’s routing table will be advertised to other nearby routers. For example, the route for the
Cellular Router’s Ethernet subnet could be advertised to a Router on the PPP interface side so that a
Router on this network will know how to route to a device on the Cellular Router’s Ethernet subnet. You will
have to add the routes appropriately in the Static Routes section – see Adding Static Routes.
NOTE – it is possible that some routers will ignore RIP.
The RIP facility is available on the Routing HTML page.
Simply click enable in the RIP Routing section on the Routing Page
Click Save
Revision 1.55
NetComm Limited
March 2009
51