Netcomm NTC-990 Manuale Utente
11.2.9
I am having problems getting a PPTP connection.
Check the routes on the “Routing” page
There should be 5 routes shown.
• One route for interface eth0.
• Two routes for interface ppp0.
• Two routes for interface ppp1.
• Two routes for interface ppp0.
• Two routes for interface ppp1.
If there are not 5 routes it is most possible:-
• PPTP is not enabled.
• The credentials on the PPTP HTML page are wrong, either the IP address or username, password.
• The credentials on the PPTP HTML page are wrong, either the IP address or username, password.
Check the logfile:
• If you see the message: “The synchronous PPTP option is NOT activated” or “CHAP Authentication
Failure” then the credentials are incorrect.
Revision 1.55
NetComm Limited
March 2009
63