Fujitsu DL7400 Manuale Utente

 
At this point, load paper and run the printer self-test. The self-test checks 
printer performance and print quality before you connect the printer to 
the computer. Use either single sheets or continuous forms (see Chapter 
3). This section describes the self-test procedure using single sheets. 

To print the self-test, use paper wider than 215.9 mm (8.5 inches) and set 
the left paper guide all the way to the right to avoid clipping the test 
pattern. Standard letter or A4 size paper can be used lengthwise (portrait 
mode).  Pull the subguide out as required to accommodate the paper size. 

Before loading paper, make sure that the printer is on. Then, proceed as 
follows: 

1.  Press the PAPER PATH button on the control panel to select the 

cut sheet mode (the CUT SHEET indicator LED lights). 

 

2.  Insert a sheet of paper (A4 or larger) into the printer, keeping it 

aligned with the paper guide on the left hand side of the paper 
table. The sheet will automatically be pulled into the printing 
start position.