Garmin NX200 Manuale Utente

Solving Problems

Check the solutions below if you’re having trouble using your NX200 Series.

■

Make sure your original is positioned in the front right corner of the glass. If 
the edges are cropped, move your original away from the edges slightly.

■

Make sure your paper is loaded short edge first and is positioned against the 
right side with the edge guide against its left side. Don’t load paper above the 
arrow mark inside the edge guide.

■

Make sure the paper size settings are correct for the paper you loaded.

■

If paper doesn’t feed, remove it from the sheet feeder. Flip through the stack to 
separate the sheets a little. Then reload the paper against the right side, and 
slide the left edge guide against the paper (but not too tightly). 

■

Do not load too many sheets at once. Load up to 20 sheets of photo paper, 80 
sheets of matte paper, or 120 sheets of plain paper. Load other special papers 
one sheet at a time.

■

Do not load paper with holes punched in it.

b

paper light flashing

 shown in Copies window

The connected USB device is not supported. 
Disconnect the device and press the y Stop button to 
continue.

P

On light flashing

b

paper light on

B

ink light on

 shown in Copies window

Parts inside the NX200 Series are at the end of their 
service life. Contact Epson for help (see page 40).

All lights are flashing

 shown in Copies window

There is a problem with the NX200 Series. Turn it off, 
wait a few moments, and turn it back on again. If the 
error is not resolved, contact Epson for help (see 
page 40).