Zebra Technologies XI4TM Manuale Utente
151
Troubleshooting
Miscellaneous Printer Problems
1/7/10
Xi4™/RXi4™ User Guide
P1009874-002
Miscellaneous Printer Problems
identifies miscellaneous problems with the printer, the possible causes, and the
recommended solutions.
Table 17 • Miscellaneous Printer Problems
Problem
Possible Cause
Recommended Solution
The LCD displays a
language that I
cannot read
language that I
cannot read
The language parameter was
changed through the control
panel or a firmware command.
changed through the control
panel or a firmware command.
1.
Press
SETUP/EXIT
to enter configuration
mode.
2.
Press
MINUS (-)
.
The printer displays the
LANGUAGE
parameter in the current language. Even if
you cannot recognize the characters
displayed, you can still scroll to another
language.
you cannot recognize the characters
displayed, you can still scroll to another
language.
3.
Press
PLUS (+)
or
MINUS (-)
to scroll
through the choices until you find a language
that you can read.
that you can read.
4.
Press
SETUP/EXIT
.
The LCD displays
SAVE CHANGES
in the
original language.
5.
Press
NEXT/SAVE
to exit configuration
mode and save the changes (if the language
does not change, you may need to scroll to a
different save option by pressing
does not change, you may need to scroll to a
different save option by pressing
PLUS (+)
or
MINUS (-)
in the previous step).
6.
Repeat this process, if necessary, until you
reach the desired language.
reach the desired language.
The LCD is missing
characters or parts of
characters
characters or parts of
characters
The LCD may need replacing.
Call a service technician.
Changes in
parameter settings
did not take effect
parameter settings
did not take effect
Parameters are set incorrectly.
1.
Set parameters and save permanently.
2.
Turn the printer off (O) and then on (I).
A firmware command turned
off the ability to change the
parameter.
off the ability to change the
parameter.
Refer to the Programming Guide for the printer
language being used, or call a service technician.
language being used, or call a service technician.
A firmware command changed
the parameter back to the
previous setting.
the parameter back to the
previous setting.
Refer to the Programming Guide for the printer
language being used, or call a service technician.
language being used, or call a service technician.
If the problem continues, there
may be a problem with the
main logic board.
may be a problem with the
main logic board.
Call a service technician.