Canon H12-4603 Manuale Utente

1 - 9 

 

2-2 New Error Codes and Recovery Methods 

Those error codes that have been added starting with the product and those error codes for 

which remedies unique to the product are offered are shown together with causes and 

remedies, where applicable.

 

 

##341 Maintenance jet waste ink capacity full 

Solution: Replace the waste ink absorber as follows in the error occurs: 

(1) Select [7] PRINTER TEST in the service mode and select [5] INK ABS CAPA under the [7], then 

input “0”.    

(2) Check to make sure that no image exist in memory; then, turn off the power, remove the appropriate 

parts, and replace the waste ink absorber.   

 

##342 Cleaning absorption waste ink capacity full 

Solution: Replace the waste ink absorber as follows in the error occurs: 

(1) Select [7] PRINTER TEST in the service mode and select [5] INK ABS CAPA under the [7], then 

input “0”.    

(2) Check to make sure that no image exist in memory; then, turn off the power, remove the appropriate 

parts, and replace the waste ink absorber. 

 

##343 Ink detection waste ink capacity full 

Solution: Replace the waste ink absorber as follows in the error occurs: 

(1) Select [7] PRINTER TEST in the service mode and select [5] INK ABS CAPA under the [7], then 

input “0”.    

(2) Check to make sure that no image exist in memory; then, turn off the power, remove the appropriate 

parts, and replace the waste ink absorber.

 

##352 Printer control EEPROM head information error 

Cause: The EEPROM for printer control is faulty. 

Solution: 

(1) Turn off and then on the power. 

(2) Turn off the power, and replace the printhead. 

(3) Replace the SPCNT board. 

NOTE: 

In the presence of ##352, the carriage unit will not move to printhead replacement position even 

when the inner cover is opened. Moreover the carriage will not be locked in position even when the 

power is turned off. When replacing the printhead, be sure to turn off the power, and draw out the 

carriage before replacement.