Canon 2830 Manuale Utente
Sending Methods
2-13
2
Basic Send
and Receiv
e Methods
Details of each item are shown below.
NOTE
•
You can change settings for Resolution, Density, and Image Quality before you
start sending. (See "Resolution, Density, and Image Quality," on p. 2-2).
start sending. (See "Resolution, Density, and Image Quality," on p. 2-2).
•
To cancel Manual Sending, press [End].
5
When you hear the other party or carrier signal (a high-pitched
tone), press
tone), press
(Start).
Scanning starts and the document is sent.
During the transmission, the transaction number, destination's telephone number,
and page number are displayed in the Job Monitor area.
and page number are displayed in the Job Monitor area.
[RX Start]:
This key is used only for receiving data from a fax
information service. It is not used when sending. (See
"Fax Information Services," on p. 3-41.)
information service. It is not used when sending. (See
"Fax Information Services," on p. 3-41.)
[Tone]:
Press when you want to directly call an extension line
that is connected to a PBX (Private Branch Exchange),
which accepts only tone signals. If you press [Tone], the
letter <T> appears. (See "Fax Information Services," on
p. 3-41.)
that is connected to a PBX (Private Branch Exchange),
which accepts only tone signals. If you press [Tone], the
letter <T> appears. (See "Fax Information Services," on
p. 3-41.)
< > or <
>:
Press [
▼] (reduce) or [▲] (increase) to adjust the
volume of the dial tone.
[One-touch Dialing]:
Press to specify destinations using the one-touch
buttons. (See "Address Book," on p. 2-19.)
buttons. (See "Address Book," on p. 2-19.)
1
2
3
4
5
6
7
8
9
0