IBM 201 Manuale Utente
Terminal Services and the IBM NAS Administration Console
If you are familiar with Windows operating systems, you can use Terminal Services.
In some cases, you must use Terminal Services to complete administrative tasks.
In some cases, you must use Terminal Services to complete administrative tasks.
You can access Terminal Services in two ways:
1. Through the UM Services browser, as described in step 3 on page 16.
2. By using the Terminal Services Client software.
To use Terminal Services Client, complete the following steps to install it on the
remote workstation and connect to your NAS 200 appliance:
remote workstation and connect to your NAS 200 appliance:
1. Insert the Supplementary CD into the workstation CD-ROM drive.
2. Click Start
→
Run.
3. In the Open field, type (with quotes)
"x:\Terminal Services Client\Disk 1\setup.exe"
where x is the drive letter assigned to the CD-ROM drive. Then click OK to
begin the Terminal Services Client Setup program.
begin the Terminal Services Client Setup program.
4. Accept the defaults in each window that opens or refer to the Microsoft
Windows documentation for more instructions. When the Terminal Services
Client Setup program is completed, proceed to the next step.
Client Setup program is completed, proceed to the next step.
5. Check the workstation network TCP/IP protocol configuration settings.
Connecting to the desktop through Terminal Services
To connect to Terminal Services from your workstation, do the following:
1. Click Start
→
Programs
→
Terminal Services
→
Terminal Services Client.
2. In the Server field, select the computer name of the desired NAS 200 . If the
desired NAS 200 is not listed, enter the IP address or the computer name of the
NAS 200. The computer name is predefined as IBM5194-xxxxxxx, where
xxxxxxx is the serial number located in the lower right corner of the bezel on the
front of the appliance. If you have changed the computer name from the
predefined value, use that name instead.
NAS 200. The computer name is predefined as IBM5194-xxxxxxx, where
xxxxxxx is the serial number located in the lower right corner of the bezel on the
front of the appliance. If you have changed the computer name from the
predefined value, use that name instead.
For Size, select a size other than full screen in which the NAS 200 desktop will
appear, then click Connect to start the Terminal Services Client session. A user
log in window displays.
appear, then click Connect to start the Terminal Services Client session. A user
log in window displays.
Log in. Type Administrator in the Username field, type password in the
password field, and then click OK to log in. Once you have logged in, you can
begin using Terminal Services Client to configure and manage your NAS 200.
password field, and then click OK to log in. Once you have logged in, you can
begin using Terminal Services Client to configure and manage your NAS 200.
Once you have logged into Terminal Services, you can perform administrative tasks
on the NAS 200, as if your keyboard, mouse, and monitor were directly attached to
it. The NAS 200 desktop contains a shortcut, titled IBM NAS Admin, to a special
console, the IBM NAS Administration console.
on the NAS 200, as if your keyboard, mouse, and monitor were directly attached to
it. The NAS 200 desktop contains a shortcut, titled IBM NAS Admin, to a special
console, the IBM NAS Administration console.
8
NAS 200 User’s Reference