Lg Electronics 84WS70MS Manuale Utente

(Depending on model)

Connect the display to a local area network (LAN)
via the LAN port as shown in the following illustra-
tion and set up the network settings.
This monitor only supports a wired network con-
nection.
After making a physical connection, a small
number of home networks may require the display
network settings to be adjusted. For most home
networks, the display will connect to automatically
without any adjustments.
For detail information, contact your internet pro-
vider or router manual.

y

y

Do not connect a modular phone cable to the
LAN port.

y

y

Since there are various connection meth-
ods, please follow the specifications of your
telecommunication carrier or internet service
provider.

y

y

Network setting menu will not be available
until the display is connected to physical
network.

y

y

Since there are various connection meth-
ods, please follow the specifications of your
telecommunication carrier or internet service
provider.

LAN

Router

LAN

WAN

Cable modem

ETHERNET

Internet

Internet

Follow the steps below to set up the network set-
tings. (Even if your display is already connected
automatically, running setup again will not harm
anything.)

1

 Press

MENU to access the main menus.

2

 Press the Navigation buttons to scroll to

and press

.

3

Press the Navigation buttons to scroll to

and press

OK.

4

 Select

.

5

 Select

or

.

If you select

Manual Mode, press the

Naviga-

tion and Number buttons. IP addresses will
need to be input manually.
-

: Select this if there is a DHCP

server (router) on the Local Area Network
(LAN) via wired connection, the display
will be automatically allocated an IP ad-
dress. If you’re using a broadband router
or broadband modem that has a Dynamic
Host Configuration Protocol (DHCP) server
function, the IP address will be automatically
determined.

6

 When you are finished, press

.