Teledyne 651 Manuale Utente
Computer Interface, Commands, and Data Collection
Teledyne API Ultrafine Particle Monitor - Model 651
68
07506C DCN6727
To enable Telnet in Windows 7 operating system, follow these
instructions:
instructions:
1. From the Start menu, choose Control Panel and then choose
Programs and Features
.
2. Choose Turn Windows features on or off.
3. Choose Telnet Client and then click OK. A dialog box appears
confirming the installation of new features.
To monitor system status using the Telnet client, follow these
instructions:
1. Insert an Ethernet cable into the Ethernet port on the back
panel of the M651 and connect the cable to your network or a
personal computer.
personal computer.
2. On the M651 home screen, choose SETUP then choose MORE to
view the NETWORK SETUP screen.
3. On the NETWORK SETUP screen, choose ADDRESS and enter a
static IP address for this unit that is available on your network.
Alternately choose NETWORK and select DHCP. If your network
has a DHCP server, a dynamic address will be selected for you
in a few seconds.
Alternately choose NETWORK and select DHCP. If your network
has a DHCP server, a dynamic address will be selected for you
in a few seconds.
4. If you are using a personal computer, from the Start menu,
choose Run then type the command telnet xx.xx.xx.xx where
xx.xx.xx.xx
xx.xx.xx.xx
is the IP address determined in step 3.
5. A console screen appears which allows direct entry of firmware
of commands.
To test communication between the personal computer (or your
network) and the N-WCPC, follow these instructions:
network) and the N-WCPC, follow these instructions:
1. From the Start menu, choose Run, type cmd and press Enter.
2. In the resulting window type ping xx.xx.xx.xx where xx.xx.xx.xx is
the IP address determined in step 3 above.
3. The response shows the response from the instrument if the
network connection is valid as shown in the figure below.