NEC LCD200VX Manuale Utente
13
Monitor
AccuSync™ LCD200VX
Notes
Specifications
Monitor
LCD Module
Diagonal :
20.1 inch
Active matrix; thin film transistor (TFT)
Viewable Image Size :
20.1 inch
liquid crystal display (LCD); 0.255 mm dot
Native Resolution (Pixel Count) :
1600 x 1200
pitch; 250cd/m
2
white luminence;
400:1 contrast ratio, typical
Input Signal
Video :
ANALOG 0.7 Vp-p/75 Ohms
Digital Input: DVI-D
Sync :
Separate sync. TTL Level
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. Positive/Negative
Sync on Green (Video 0.7Vp-p and Sync Negative 0.3V p-p)
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. Positive/Negative
Sync on Green (Video 0.7Vp-p and Sync Negative 0.3V p-p)
Display Colors
16,777,216
Dependent on display card used.
Maximum
Left/Right :
80°/80°
Viewing Angles
Up/Down :
80°/80°
Synchronization
Horizontal :
31.5 kHz to 91.1 kHz
Automatically
Range
Vertical :
56.0 Hz to 85.0 Hz
Automatically
Resolutions Supported
720 x 400*
1
:VGA text
Some systems may not support all modes listed.
640 x 480*
1
@ 60 Hz to 85 Hz
800 x 600*
1
@ 56 Hz to 85 Hz
832 x 624*
1
@ 75 Hz
1024 x 768*
1
@ 60 Hz to 85 Hz
1152 x 870*
1
@ 75 Hz
1280 x 1024*
1
@ 60 Hz to 85 Hz
NEC-Mitsubishi Electronics Display cites
1600 x 1200 @ 60 Hz ............................ recommended resolution at 60 Hz for
optimal display performance.
Active Display Area
Horizontal :
408 mm/16.1 inches
Vertical :
306 mm/12.0 inches
Power Supply
100 – 240 V ~ 50/60 Hz
Current Rating
0.95 - 0.55A
Dimensions
445.0 mm (W) x 391.3-461.7 mm (H) x 213.6 mm (D)
17.5 inches (W) x 15.4-18.2 inches (H) x 8.4 inches (D)
17.5 inches (W) x 15.4-18.2 inches (H) x 8.4 inches (D)
Weight
9.4 kg
20.7 lbs
20.7 lbs
Environmental Considerations
Operating Temperature :
5°C to 35°C/41°F to 95°F
Humidity :
30% to 80%
Feet :
0 to 10,000 Feet
Storage Temperature :
-10°C to 60°C/14°F to 140°F
Humidity :
10% to 85%
Feet :
0 to 35,000 Feet
*
1
Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each
dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each
dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifications are subject to change without notice.
Specifications
ASLCD200VXmanual062204.p65
6/23/04, 8:42 AM
13